How To Change Bottom Rollers On Garage Door

How to replace the bottom garage door roller the safest way to replace the bottom roller is to bend the track so you can pop the bottom section out.

How to change bottom rollers on garage door. In case your garage door is made of steel then the hinges would be secured with hex headed screws. Using your dominant hand slide the end of a. Slide out the old roller. Install the roller into the bottom bracket and thread the cables behind the rollers on the door.

Replacing the bottom rollers 1. Use the 3 8 inch wrench to remove these. This will allow you to remove the roller from the track. Don t buy home depot or walmart rollers.

Get down and dirty. Line up the first garage door roller with the opening you just created. Take a pair of pliers and bend part of the track near the top slightly open. Find new rollers and hinges here.

Place a c clamp into the track opposite the side of the door where you intend to replace the roller. With the cable behind the roller and bracket install the bottom bracket on the garage door. Wedge a flathead screwdriver between the roller and the. Pull the garage door down so the roller lines up with the track you pried open.

After removing the nuts use a hammer to knock out the bolts. Locate the intersection of the straight. For the wooden garage door use the 7 16 inch wrench to remove the nuts that are used to hold the through bolts on the roller hinge. Replacing a bottom roller 1.

Work slowly so you don t lose control. Then bend the top of the track to slightly open it up with your pliers. Open your garage door completely and clamp the track about 2 3of the way up. Pull the bottom section of the garage door toward the inside of the garage and remove the old roller.

3 minute bottom roller change on your garage door. Raise the garage door then disconnect the electric opener s power cord from the electrical outlet. Pull the release cord and unplug the garage door opener for added safety. It will be easier to replace the roller if you raise the door a few feet off the ground.

Pop the first roller out of the track with a flathead screwdriver. If the track still contains the roller bend the track as shown in step four. Ensure to tighten them before proceeding.