How To Change A Door Lock And Deadbolt

How to change a home door handle lock combo.

How to change a door lock and deadbolt. Position the lock mechanism such that the keyhole is vertically aligned. Put on the cover. Your front door is the first thing people see when they enter your home. If the deadbolt comes with an interior plate and a decorative.

Remove the set plate and bolt. Usually the screws come with your new deadbolt. On the opposite side insert the bar into the channel in the back of the turn assembly plate. As i started to get quotes from locksmiths i nearly choked.

When we moved into our home there were four different keyed locks to our house but we only had one key to one lock. Now there are many models of deadbolt that come with a decorative cover. Remove the screws on the inside plate. This cover keeps the faceplates or facepieces hidden.

Insert the bar protruding from the new deadbolt lock through the channel in the deadbolt itself. Insert the new bolt into the opening on the edge of the door and fasten it to the door with the provided screws. In apartment complexes this is now the most common way of changing locks on a door. Insert the exterior part of the lock into the door by feeding the long metal piece through the opening in the center of.

Generally you can pull it straight out though in some cases you might need to twist the faceplate counterclockwise before pulling it. Rekeying involves realigning the pins and springs in the inner workings of the lock in. The part of the lock that the screws are in is known as the faceplate step 2 pull out the interior faceplate. Rekey the old deadbolt or take.

Step 1 remove the screws of the deadbolt. Make a good impression on guests by swapping out your old beat up lockset. Don t use any other screws since that would result in a poor fitting. Here are top 5 door lock installation kits you may love to check this out.

Some were over 200 to replace two locks. Once the screws are removed you ll either. Changing a deadbolt 1. This was not in our budget.

Once the screws have been removed the faceplate can be pulled out. Orient the turn assembly plate such that its top side is at the top. Remove the old deadbolt faceplates. The set plate and bolt are the final components of the lock and are fastened to the.