How To Attach Cord To Garage Door Bottom
Prepare the new cable by cutting off any pieces of tape wrapped around it.
How to attach cord to garage door bottom. The cables attach at the bottom end to the bottom bracket that is mounted to the bottom of the bottom panel. Remove the cable from the bottom bracket and then completely remove the cable from the door. Rotate the drum to wind the cable into the winding grooves. Install the roller into the bottom bracket and thread the cables behind the rollers on the door.
Insert rollers into the brackets attached to the door. Then drill and screw the track to the back of the door using 1 in. Pull the cable as tight as possible before tightening the setscrews. Clamp it into place.
This video will show you how to repair a mis aligned garage door cable. Screw cable brackets to the door to secure the weather stripping. Always be careful when using a sharp knife. With the cable behind the roller and bracket install the bottom bracket on the garage door.
Use impact driver to mount hinges to the bottom panel of garage door. Push the track into wet caulk and tight against the door bottom. Fasten a new garage door bottom seal to a wood garage door. If your garage door cable is at an angle or l.
Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Attach weather stripping to the bottom edge of garage door. Diy garage door repair and save money. Leave the locking pliers in place and repeat the tightening procedure on the other side.