How To Adjust Springs Garage Door

Adjust the spring into the proper position and make sure your garage door closes all of the way.

How to adjust springs garage door. If the door was closing too quickly move the spring to the next higher hole on the bracket. Take note of the notches and screws that hold the torsion spring in place. Adjusting garage door springs is a common repair. The rod will need to be at least 18 inches long and 1 2.

If it was opening too quickly move it to the next lower hole. Retest the door. Garage door springs are used to offset the weight of the door. Troubleshooting garage door springs.

When garage doors won t close all of the way or they close unevenly spring adjustment may be called for. Adjust the springs on both sides of the door the same way. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out.

Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel. The other is attached to a pulley connected to the cable. Next get hold of one of the tension rods and push it into the first notch. Adjusting garage door extension.

How to adjust a torsion spring garage door step 1. Use a metal rod to stick in the first notch of the cone. It should be placed on the left hand side of the torsion spring and placed away from the garage door s center. Without the springs the door is very difficult to lift.

One end of the spring is connected to the garage door track or frame. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. How to safely adjust your garage door spring. The cone is on the torsion spring on the left side away from the.

Look for a reddish cone on the torsion spring. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.