How Do You Lay Roll Roofing

The strips should always be horizontal.

How do you lay roll roofing. A gas burner is held so that it warms up the ground surface and the lower surface of the material. How to do it attach first course. Fix edge fabric roll. The canvas is rolled up into a roll back to the point of attachment.

An underlayment of felt roofing is optional. The roofing should overhang the eaves by inch except where you install drip edge flashing on top of the roofing along the rake edge. You need to place starter strips of roll roofing along all edges of the roof so start by cutting pieces of roofing about 18 inches wide. Roll roofing is not very pliant or flexible in cold weather of fewer than 45 degrees fahrenheit and it can crack and break if.

Be careful not to get any on your skin in this process. To seal a plumbing vent spread roofing. Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a. For this heat up the gas burner and push it to the edge of the site where it will be fixed.

How to properly install roll roofing. Step 3 apply the edge strips. If possible install roll roofing over a smooth plywood deck either perpendicular or parallel to the slope. Plan so that no two butt joints are closer than 2 feet from each other.

To install roll roofing you ll need to cut the material into long strips of the correct length for your roof and lay it flat.