How Do I Program A New Genie Garage Door Opener

Programming genie intellicode remote transmitters gently press and release the receiver learn code button on the power head receiver of your door operator.

How do i program a new genie garage door opener. Place the ladder under the garage door power head and climb so you are within reach of the control buttons. Place the battery cover back on the remote control and press the white button on the remote control. Slide each individual switch on the remote control to the exact position each switch is on the door opener with your finger. This may require the use of a ladder follow all safety precautions.

Step 2 press and hold the learn button on the side of the power head for approximately 10 seconds or until the indicator light turns off. This small black unmarked button is located behind the light lens at the motor head and is nearest the floppy 6 inch antenna wire that protrudes from the motor head. The led on the garage door opener will go on immediately. If the genie door opener does not operate one or more of the dip switches is not set correctly.

Place the garage door opener into learn mode by pressing the small square colored button or the small round black button on a genie located behind the light bulb globe in the garage.