How Do I Fix My Garage Door Spring

This tension makes it easier to lift the garage door from its closed position.

How do i fix my garage door spring. Side mounted springs are long heavy springs mounted on each side of the upper garage door track. Replacing garage door springs is not a do it yourself project replacement requires special tools and techniques to prevent injury. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Secure the door open preferably using c clamps.

This is when injuries occur. A garage door should not be opened until the spring is repaired. In order to replace your garage door spring s you will need to find the current measurements in order to accurately replace the spring s. Disconnect the garage door opener so the door remains.

Removing the old springs 1. However when you need to get your car out of the garage it may be necessary if you cannot wait for the repairman. After you then disconnect the safety cable from one end. Unplug the garage door opener and clamp the door to the track.

Once the tension is released you can remove the spring from the track. If the door remains in place the replacement was a. Loosen the unbroken spring. Lubricate the spring with garage door lubricant then remove the clamp from the garage door.

The size of the door and the type of spring system determines how difficult opening the door will be. First do not try to lift the door by hand or using the opener as you can hurt yourself lifting a heavy garage door by hand and burn out the opener using it to try to open a door with a broken spring. Position a sturdy ladder to the side of the. Leaving the garage door open and securing it ensures that the tension on the spring is released.

Unwind each spring with the. This should take about 3 minutes and you don t need to remove the springs or loosen the tension to measure them. When you are using a winding bar to tighten the spring the bar may slip out and cause a sudden release of the spring s tension. How to repair garage door springs and cables lock down the door.

Shove a winding bar into a bottom hole of the winding cone of the good spring. Clamp a locking pliers or a c clamp to the track just above one of the rollers. There are shallow holes or slots in the winding cone into which a winding bar is placed to help you turn the spring to tighten or loosen it.