How Do I Apply Paneling To Walls

Place the panel on the wall and press it into the adhesive.

How do i apply paneling to walls. Gently remove any crown moulding baseboards and trim you plan on using again. Secure the paneling to the wall with panel adhesive and finishing nails. With the right tools and patience you can do an frp installation. The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.

Any room with a frp panels installation are easy to clean and hard to stain. Adhesive may be used to fasten panels to a smooth well adhered surface. Paneling is sold both in boards and sheets but sheets are generally a little easier to install. On the back of each panel place a 1 4 bead of adhesive about 1 from the edges of the panel.

Pull the bottom edge of the panel about 6 inches from the wall and push a block behind the sheet. Smear a quarter size amount of the panel adhesive onto the wall. Water resistant and durable frp or fiberglass reinforced paneling resist mildew and mold and work great in laundry rooms and bathrooms. Pull the panel away from the wall and let the adhesive become tacky.

Drive four finishing nails through the top edge of the panel. Load a caulking gun with a tube of panel adhesive and apply a small dab of it on the wall about every 10 inches. Trim the inside edge the edge in the corner of the panel if necessary to allow the panel to hang properly. Install the panels to the wall studs with finishing nails or a pneumatic nailer.

This will allow it to adjust to the humidity in a room. Paneling adhesive sold in tubes is the easiest with which to work. Wait until you get the paneling up on that section before you move on to another one. Apply adhesive to the framing in a wavy pattern.

Position the panel on the wall leaving a 1 4 inch space at the bottom and drive the four nails partway into the wall. Use a level to check the outer edge of the first panel. For best results set the paneling in the room for a few days before you install it. The tubes fit standard caulk guns for an easy method to apply the adhesive.

Repeat every 10 inches 25 4 cm up down and across the section of the wall where the first plywood panel will go. Only apply the panel adhesive to one section of the wall. Place the first piece of paneling in a corner of two walls.